What to do?
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2009
Location: illinois
Posts: 183
Total Cats: -4
What to do?
Ok. I hope Adaptronic comes in tomorw. I have all my lines already ran and soldered as the instructions state. I even ran the 5/16 line from the back of the manifold to a t of 1/4 i believe it was. All thats left is to connect three wires (ground, source, and power to the map from MAF and IAT) and plug and play right? But, once I get this installed under my dash and connect my computer to it, should I load the 600cc map packs from boundary engineerings web page, then do the idle setup manual that Travis had just made? Or do i not even bother with the 600 cc map pack? It would be really nice if someone had a map for a 99 with d' 600 cc injectors and a gt2860. But, i'm just trying to look for advice. BTW I'm a complete noob to all this stuff.
#2
Ok. I hope Adaptronic comes in tomorw. I have all my lines already ran and soldered as the instructions state. I even ran the 5/16 line from the back of the manifold to a t of 1/4 i believe it was. All thats left is to connect three wires (ground, source, and power to the map from MAF and IAT) and plug and play right? But, once I get this installed under my dash and connect my computer to it, should I load the 600cc map packs from boundary engineerings web page, then do the idle setup manual that Travis had just made? Or do i not even bother with the 600 cc map pack? It would be really nice if someone had a map for a 99 with d' 600 cc injectors and a gt2860. But, i'm just trying to look for advice. BTW I'm a complete noob to all this stuff.
Good luck mate.
Ted