AEM FIC wiring from boomslang
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Apr 2009
Location: illinois
Posts: 183
Total Cats: -4
AEM FIC wiring from boomslang
Boomslang makes one now for 99-00 miatas. I asked if they made them with the resistors already soldered in.
"We build the FIC harnesses with a 10K ohm resistor on the O2 sensor.
We can also add a 10K resistor to the MAF sensor if you would like. This resistor is standard on the 01-05 Miatas.
"
This is what was sent to me. I've read some have a 1 k resistor on the MAF sensor not a 10k. Which one should i have them solder in? I plan on just installing the fic to do data logging (pre boost) to get some values on maximum voltage so I can clamp my MAF if needed and should I decide to go over 15lbs of boost. Thanks for the advice.
"We build the FIC harnesses with a 10K ohm resistor on the O2 sensor.
We can also add a 10K resistor to the MAF sensor if you would like. This resistor is standard on the 01-05 Miatas.
"
This is what was sent to me. I've read some have a 1 k resistor on the MAF sensor not a 10k. Which one should i have them solder in? I plan on just installing the fic to do data logging (pre boost) to get some values on maximum voltage so I can clamp my MAF if needed and should I decide to go over 15lbs of boost. Thanks for the advice.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM