ls1motorsports

iTrader: (1)

Boomslang makes one now for 99-00 miatas. I asked if they made them with the resistors already soldered in.

"We build the FIC harnesses with a 10K ohm resistor on the O2 sensor.



We can also add a 10K resistor to the MAF sensor if you would like. This resistor is standard on the 01-05 Miatas.
"

This is what was sent to me. I've read some have a 1 k resistor on the MAF sensor not a 10k. Which one should i have them solder in? I plan on just installing the fic to do data logging (pre boost) to get some values on maximum voltage so I can clamp my MAF if needed and should I decide to go over 15lbs of boost. Thanks for the advice.