COP/Injector wiring
#1
COP/Injector wiring
I just finished swapping my 2000 running EMS4 into a 1990. I had COPS and injectors running sequentially on the 2000, which was setup a couple years back. I referred to my original install notes, but now not sure I did it correct this time. I have assumed that both injectors and coils number from 1-4 beginning from front of motor and going straight back in order, and then wires go to pins per schematic (i.e. coil 3 is pin 8 and coil 4 is pin 9). Same would be true for injectors.
Just want to verify that I should not be assuming firing order with regard to the wiring.
Just want to verify that I should not be assuming firing order with regard to the wiring.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM