When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Assuming it should be a steel fitting, I need to find my old 10an cap from the last oil drain I did.
Dont do that. Mine gushed oil. maybe if you connect from that hole to the back of the valve cover. But I've been fine with just the exhaust side with a big bung, drilled holes, and chore boys.
VD shows my car makes about 400-420whp with four ID 1000's maxed out, 60 PSI base and 1:1 reference and holding fuel pressure to redline, on E85. But ebay all the things and conservative tune. If he made 450whp @ 88% duty cycle, then in theory at 100% ((450/88)*100 = 511) he could have made 511whp. I don't think anyone makes that kind of power on E85 with ID 1000's, do they?
I've seen a couple cars do that, but all were running fancy surge tank fuel setups. My wrx was at 93-5% iirc at 428 60 base pressure and dw65c (255lph)
I know the plot. I was there. You weren't even part of MT back then
I don't even know (or care) what you y'all are debating. Just adding my experience. I hope you make 600 on the ID1k's
VD shows my car makes about 400-420whp with four ID 1000's maxed out, 60 PSI base and 1:1 reference and holding fuel pressure to redline, on E85. But ebay all the things and conservative tune. If he made 450whp @ 88% duty cycle, then in theory at 100% ((450/88)*100 = 511) he could have made 511whp. I don't think anyone makes that kind of power on E85 with ID 1000's, do they?
Unless you datalogged fuel pressure there is a good chance it does not hold 60psi reference until redline. It also obviously depends on what fuel ratio you are targeting.
With a single walbro450 I dropped like 4psi at full power on the dyno. I also found out my fuel sock was pinched against the bottom of the tank. Moved the pump up and will be trying again. Interested to see if it's any different.
I run an -05 tube nut with a -05/-06 male union, all steel Aeroquip. I could only find a -06 5/16 tube nut in JIC, which felt like bad juju although fine on paper.
I think most tube nut issues (aside from mixing 37/45, which I assume Leafy didn't do) are from using a 37 degree flare tool meant for relatively soft hard lines. Mine is rated for stainless.
Ok sounds goodml. I will cancel my compression fitting order. Link me the tube nut stuff. How about I pick it up at mrls and ship it back to you. Id be happy to leave any sort of deposit that you would like.
08-20-2016, 11:26 PM
0
