When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Here is my progress on the new fastback i am making. The side windows are flush with the door windows, and i will put the rear window in next. Then i can fill the 5mm to bring it to the finish level ready for sanding.
3rd coat, 1st topcoat. I willdo the final coat over this when it dries enough and do the final rough sand. Then check all dimensions again. If all good, i can start with the hi-fill/primer coats.
Aah nuts. I really like the lines of this top, they look much more natural and doesn't make the car look as if it had a tumor on the back where the glass is.
I uploaded a walk around video of the fastback. The last coat of filler has just been applied. So i will sand that tonight, and hopefuly it will be ready for the primer/hifill.
I have made the bottom edge of the back window the shut line for the boot/trunk. For now I am happy to mould the fastback outer with flanges, and then look at doing all the inner/undercut areas for the next stage. As I have to have the car ready for a track day next weekend.
I did some checking, and the left rear corner was a bit lower, and where the fastback part meets the roof part had too sharp of a curve. So it has had a lot more filling and sanding. It is very close now. It should be ready for primer tonight.