MX5 Turbo Build
10-12-2015, 01:24 PM
#1
Junior Member
Thread Starter
Join Date: Mar 2015
Location: UK
Posts: 52
Total Cats: 0
MX5 Turbo Build
Afternoon MiataTurbo
I'm currently in the middle of turbo'ing my newest MX5, however i have hit a few problems.
The car is a MK1 Eunos 1.6 1990.
I have wired up my MS2 V3 but having a problem with a couple of things.
Crank In – Spliced into 2E ( there 3 wires within one, it a main think grey wire)
- I have read I only connect the BLUE wire, is this correct?
Also because my car doesn’t have VTPS I have wired up TPS as follows
- TPS SIG > Ground
- TPS 5V > Taped Up
Is the above right?
I have plugged the MS2 into the car, it primes the fuel pump (Spliced into green wire yellow harness) but doesn’t fire.
When connecting to Ecu there no crank signal :(
I'm currently in the middle of turbo'ing my newest MX5, however i have hit a few problems.
The car is a MK1 Eunos 1.6 1990.
I have wired up my MS2 V3 but having a problem with a couple of things.
Crank In – Spliced into 2E ( there 3 wires within one, it a main think grey wire)
- I have read I only connect the BLUE wire, is this correct?
Also because my car doesn’t have VTPS I have wired up TPS as follows
- TPS SIG > Ground
- TPS 5V > Taped Up
Is the above right?
I have plugged the MS2 into the car, it primes the fuel pump (Spliced into green wire yellow harness) but doesn’t fire.
When connecting to Ecu there no crank signal :(
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
