Lc-1 reading 20+ F/R ratio when in gear but no gas applied
04-10-2012, 06:59 PM
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jun 2009
Location: Los Angeles, California
Posts: 176
Total Cats: 0
Lc-1 reading 20+ F/R ratio when in gear but no gas applied
My LC-1 is reading 20+ F/R ratio when i am in gear but no gas is applied (no throttle). Other than that, it reads perfectly. I have it hooked up to my MSPNP. Anyone has the same problem?
Reply
0
0
04-10-2012, 07:17 PM
#2
It's the Over Run fuel cut settings under the Extended menu. Basically the ecu cuts fuel to your injectors below a certain KPA, the stock ECU does the same thing. You can turn it off; waste gas and not really notice any difference if it makes you feel better.
I'm pretty sure I bumped mine up a good bit (more aggressive) from the base map settings. Current settings are below 25kpa, less than 5% throttle position, and greater than 1500rpms and it drives like stock.
I'm pretty sure I bumped mine up a good bit (more aggressive) from the base map settings. Current settings are below 25kpa, less than 5% throttle position, and greater than 1500rpms and it drives like stock.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
