Kirby

Hey guys i just got my turbo running, but it seems my oil supply line is too big and is putting too much oil pressure into the T-25 turbo. Im running a -4an line and i need to run a -3an. Does anyone know where i can get a 10mmX1.5 to -3an adapter to use on my block? Or something that would reduce the pressure on a -4an line. Im so close to finishing this turbo and it's killin me to have these little problems.

Thanks!

Braineack

iTrader: (62)

Buy a restrictor.

I run this one personally:

http://www.atpturbo.com/Merchant2/me...egory_Code=OIL

or if you are gung-ho on running a -3an line then:

http://www.atpturbo.com/Merchant2/me...egory_Code=OIL

Kirby

how does the oil restrictor hook up? Does it attach to the turbo? Will this work on my -4an line?

Sirnixalot

screw the adapter into the turbo and screw the -4an line onto the adapter...

Kirby

My T25 uses a 7/16 inlet thread that restrictor uses a 1/8 npt though so i think i might have a problem

Braineack

iTrader: (62)

K, what about this instead.

http://www.extremepsi.com/store/cust...cat=336&page=1

screw that into the turbo and the line right into that. Might want to get a 90* fitting

Kirby

I just ordered that restrictor, Thanks Braineack for the help, it was much appreciated

Sirnixalot

atp had what you were looking for as well, shoulda found it if you looked in the oil supply section

http://www.atpturbo.com/Merchant2/me...egory_Code=OIL