2* IGN advance - spoolup
#1
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Atlanta
Posts: 7,486
Total Cats: 372
2* IGN advance - spoolup
Starting to tweak my IGN map with some street tuning. "Added" 1 and then 2 degrees of ign advance to the overal map. No knock and there was a consistent gain in spoolup across the board. Even with the ambient temp diff and greater heat soak. I can only assume the onset was ambient temp.
Before (50F ambient)
Before (50F ambient)
onset = 1480
3psi = 2780
6psi = 3350
9psi = 3790
12psi = 4170
After (80F ambient)3psi = 2780
6psi = 3350
9psi = 3790
12psi = 4170
onset = 1580
3psi = 2590
6psi = 3130
9psi = 3600
12psi = 3880
3psi = 2590
6psi = 3130
9psi = 3600
12psi = 3880
#4
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Nope. I picked up another BEGi FMU to hold me for now. But I really, really hate the AFM.
I asked FM for a refund last week since they can't get it together for me. Still no Link, and no refund either.
I asked FM for a refund last week since they can't get it together for me. Still no Link, and no refund either.
#7
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Atlanta
Posts: 7,486
Total Cats: 372
No cap install... yet. Though I'm considering a swept blade fan that's got a lower amp rating instead- at the risk of a restocking fee if it doesn't fit. Found the fan after the cap. Just skeptical of the thickness listed.
I'm surprised FM hasn't acted quickly or responded.
I'm surprised FM hasn't acted quickly or responded.
#8
http://fatcatmotorsports.com/fanshroud.htm
Have you seen this? I don't know what rad you used with your FE3 swap but it's cool none the less unless I'm missing something. Then again it's also $375 :(
Have you seen this? I don't know what rad you used with your FE3 swap but it's cool none the less unless I'm missing something. Then again it's also $375 :(
#9
Elite Member
Thread Starter
iTrader: (5)
Join Date: Jan 2005
Location: Atlanta
Posts: 7,486
Total Cats: 372
My rad is a ford circle track rad- nearly square in shape. I did build a set of shrouds for my narrowed aluminum Miata rad out of steel flat stock and sheet metal, using two 14" fans and it worked quite well. Can't see forking over that kind of dough for one though.
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM