Low impedence to high impedence...
#1
Low impedence to high impedence...
I just picked up a set of RC550 injectors that were advertised as high impedence, which is what i'm 99% sure is what i need as i will be running MSPNP. The injectors just arrived, and are in fact low impedence (tested them myself at 2.6 ohms.)
I have an option of sending them back, or i suppose i could try to make them work with resistors. What exactly is involved in going the resistor route? Where are the resistors installed, and which resistors do i need? Would i be better off buying high impedence injectors. I paid quite a bit for the injectors, primarily because i thought they were high impedence.
Thanks for your advice.
I have an option of sending them back, or i suppose i could try to make them work with resistors. What exactly is involved in going the resistor route? Where are the resistors installed, and which resistors do i need? Would i be better off buying high impedence injectors. I paid quite a bit for the injectors, primarily because i thought they were high impedence.
Thanks for your advice.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM