albertogti117

iTrader: (2)

Hey guys,

Last night I managed to snap the banjo bolt that goes on the oil feed of the Greddy td04

I was able to find a M10x1.25 banjo bolt that was just about the same length as the stock Greddy banjo bolt. However, the holes on the new bolt are slightly smaller than the holes on the stock bolt.

Is this okay to run or should I drill out the holes a little bigger? I have heard that the Greddy oil feed line is a bit larger than it needs to be so perhaps I could get away with running a banjo bolt with smaller holes? I have attached a few pictures showing the difference in diameter of the holes. Also note that the new bolt does not have a recess at the end of it like the Greddy banjo bolt.