Building a DIY on a B6 nbb miata
07-12-2009, 10:22 PM
#23
Cpt. Slow
iTrader: (25)
Join Date: Oct 2005
Location: Oregon City, OR
Posts: 14,178
Total Cats: 1,129
FWIW, I've tracked my Greddy turbo with the FM (Bowser technically) heat shield and no other heat reflective wrapping, and haven't melted anything. I maybe just lucky though.
Reply
0
0
07-13-2009, 04:14 PM
#26
Junior Member
Thread Starter
iTrader: (1)
Join Date: Jul 2008
Location: The Netherlands
Posts: 101
Total Cats: 0
about the boost gauge:
I don't know if the brand is sold in the states, but the brand is SLM.
I made the choise because it is the best fit to the gauge of my LC-1.
about the turbine housing:
I'm not complete surtain that it is an tb2525, I bought it from a guy in the Netherlands that also comes to this forum: Gredddymx5.
A GT25 based turbo will fit the greddy manifold, the standard DP will nof fit.
In my case that didn't botter me because there is no bolt om solution for my B6 nbb mx-5.
The a/r ratios on the turbine and compressor housing gives me the inpression that it could have the same specs as an gt2554, but for that I'm not shure.
The a/r ratios are the only pieces that are still the on the housing.
It fun.
If someone now a webstore in europe for a actuator bracket that is mounted to the turbinehousing, I will be glad.
Otherwise I must order at bell. Not that I don't want to, but shipping cost are a bit high only for a bracket.
Fotos of the whole car:
Foto is from my wedding novebmer 2008.
I don't know if the brand is sold in the states, but the brand is SLM.
I made the choise because it is the best fit to the gauge of my LC-1.
about the turbine housing:
I'm not complete surtain that it is an tb2525, I bought it from a guy in the Netherlands that also comes to this forum: Gredddymx5.
A GT25 based turbo will fit the greddy manifold, the standard DP will nof fit.
In my case that didn't botter me because there is no bolt om solution for my B6 nbb mx-5.
The a/r ratios on the turbine and compressor housing gives me the inpression that it could have the same specs as an gt2554, but for that I'm not shure.
The a/r ratios are the only pieces that are still the on the housing.
It fun.
If someone now a webstore in europe for a actuator bracket that is mounted to the turbinehousing, I will be glad.
Otherwise I must order at bell. Not that I don't want to, but shipping cost are a bit high only for a bracket.
Fotos of the whole car:
Foto is from my wedding novebmer 2008.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
