turbopezz

ok i have to order my oil fee line and just want some reinsurance.(i have a 1.6 & gt28r)

#1.m10x.15 to -4an
#2 -4an female swivel ends
3ft of -4an line
and a -4an to 10x1.25

turbopezz

any one positive..

Braineack

iTrader: (62)

if the turbo is m10 x 1.25 then it all sounds good to me!

jayc72

iTrader: (14)

Are you going to have to run a restrictor?

turbopezz

i dont think so.

bripab007

I believe a lot of those GT28 turbos have restrictors built into the CHRA. FM always used -4AN lines with their kits and no in-line restrictors, only relying on the internal ones, so if that's the case, you'll be fine.

turbopezz

thanks for helping clear that up. .but i know the turbo feed thread cant be m10 x 1.25 .i think its 12x1.25.i guess im gona have to go to sears and match it up but it sucks cause i cant drive there.

bripab007

Yeah, 10mm x 1.25 sounds small for the turbo feed opening. Most of the Mitsubishis are like 12mm x 1.5.

kung fu jesus

iTrader: (1)

that sounds right.

if the oil feed line comes with swivel ends, it makes it easier to install. i had to use a 90* -4 an fitting off the 10x1.25 adapter on the gt25r i had.

turbopezz

yea i checked this yesterday its the same as a mitsu turbo.but the tread is finner than 12x1.5.so i think its a 12x1.25.oh im using a tap and die set to figure it out but ofcourse i dont have a 12x1.25 size

turbopezz

ok here it is 12x1.25 is for
nissan t25,t28
mitsubishi t25,14b,and probaly 16gs.

jayc72

iTrader: (14)

The mitsu turbo with the greddy kit is M10 not M12.

turbopezz

thats a 15g?

jayc72

iTrader: (14)

Td04h-15g

neogenesis2004

iTrader: (12)

i dont want to thread jack, but what length do the feed and return lines need to be. I'm getting ready to buy my ss hose and as much as this stuff cost I don't want to buy TOO much. I'll be using a begi manifold if that helps...

Braineack

iTrader: (62)

you'll want around 36-48"

Just take a bit of wire or string and kinda mock it out and see.