chinacharger in the mail... ill give updates when it gets in
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Pittsburgh, pa
Posts: 78
Total Cats: 0
chinacharger in the mail... ill give updates when it gets in
I bought a chinacharger that specs out to a garrett 2871 roughly. Im excited to see how it works and what the quality is like. I got it for 299 shipped and should have it tomarrow or fri. Hopefully its good and a few of you guys can get a good turbo cheap.
3" Inlet Diameter
Journal Bearing - Wet Float Type
t25 Flange
Oil Lub, Oil/Water Cool
Ideal for smaller displacement engines making up to 420hp
Compressor Wheel
0.60 A/R Cold Side
Ind: 54.00 mm
Exd: 70 mm
Trim: 60
Turbiner Wheel
.64 A/R
Garrett 4 Bolt T25 Flange
Ind: 52.90 mm
Exd: 45.47 mm
3" Inlet Diameter
Journal Bearing - Wet Float Type
t25 Flange
Oil Lub, Oil/Water Cool
Ideal for smaller displacement engines making up to 420hp
Compressor Wheel
0.60 A/R Cold Side
Ind: 54.00 mm
Exd: 70 mm
Trim: 60
Turbiner Wheel
.64 A/R
Garrett 4 Bolt T25 Flange
Ind: 52.90 mm
Exd: 45.47 mm
#5
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Pittsburgh, pa
Posts: 78
Total Cats: 0
Just got it in the mail! Looks really really nice, came packaged with gaskets, covers over compresser and turbo inlet/outlets. And heck even instructions hahaha. But works getting in the way ill have to put it on tomarrow morning and take pictures
#12
Junior Member
Thread Starter
iTrader: (1)
Join Date: Sep 2009
Location: Pittsburgh, pa
Posts: 78
Total Cats: 0
hey guys sorry for the delay. Just got the turbo on the car and tuned it with tuner studio. Turbo fit great and produced good power. I need to get rid of my current cat eliminator(1 7/8 inch pipe). Totally slowings down my spool and boost. I have a 3 inch dp and a 2.5 inch cat back, whoops. haha. Next on the list is a better flowing intercooler off ebay and new piping. This should make my car complete.... well maybe for a day or 2!
#15
hey guys sorry for the delay. Just got the turbo on the car and tuned it with tuner studio. Turbo fit great and produced good power. I need to get rid of my current cat eliminator(1 7/8 inch pipe). Totally slowings down my spool and boost. I have a 3 inch dp and a 2.5 inch cat back, whoops. haha. Next on the list is a better flowing intercooler off ebay and new piping. This should make my car complete.... well maybe for a day or 2!
#19
I'll be running a -3 AN line so I"m hoping I won't need a restrictor. If I do, thenI am going to get this:
http://www.---------------------------/oil-res.shtml
http://www.---------------------------/oil-res.shtml