psyber_0ptix

iTrader: (4)

wait, I'm missing something...no solder for the wiring harness? Is there some impedance that shouldn't be present if using solder

Leafy

iTrader: (1)

Its a brittle joint on top of a vibrating engine, a recipe for failure.

thasac

iTrader: (3)

In theory, yes.

In practice, a well fixtured soldered joint ... even on a BP ... should hold up on 98% of the cars on this board. At least I hope so since I soldered mine

-Zach

Braineack

iTrader: (62)

define: here.

Leafy

iTrader: (1)

The whole site, you cannot solder your MS together, electrical connections on circuit boards must be made with Joe's semen.






Seriously, I mean here as in the cop harness.

shuiend

iTrader: (24)

If you are seriously considering spending $300 on the TSE COP kit I would highly suggest you go with an LS coil setup instead. Bracket and spark plug wires are $200 from FM, coils go for about $100 on ebay with all the wiring you need.

Braineack

iTrader: (62)

and why can't you crimp the pins with a needle nose and then solder them as well?

JasonC SBB

Really? I can't find it on FM's page without the coils. With the coils they're $700+.

stefanst

iTrader: (1)

I just got the bracket from them. I think it was around $40 or so. Just call them. As they say on their website: They sell you any single item from any of their kits.

BTMiata

iTrader: (5)

Yeah I was looking early and couldn't find it either

Leafy

iTrader: (1)

And then you can order the wires from magnacore for like $250 shipped, at least for the VVT fitment.

stefanst

iTrader: (1)

I found the FM part numbers, but not the prices:

26-04320 LS Coil Bracket, 1994-05 will only work with Hydras*
26-04075 Magnecor Sequential LS coil 8. 1994-00 5mm wire set For 94-00 Hydra equipped cars (45491)

codrus

FM's LSx coil kit doesn't fit with the EGR pipe. Unclear if it fits with a coolant reroute or not.

--Ian

triple88a

iTrader: (2)

Hmm how does it get in the way of the EGR?

HHammerly

iTrader: (3)

This is the way i am installing my coils, i think that they would fit on a VVT motor but have not fit tested it yet, i designed the bracket and have the DXF file if any one wants it.

Leafy

iTrader: (1)

The VVT pipe might be in the way, so you might have to offset the coils so that they dont interfere, or raise it up.

EO2K

iTrader: (37)

That actually came out really nice. Are you willing to make more mounts?

HHammerly

iTrader: (3)

I can make some more if there is interest in them, i paid $25 for the 316 stainless steel one.

sixshooter

iTrader: (12)

What's the cost to me? It looks nice.

EO2K

iTrader: (37)

I'd absolutely be down for one.