what is easy way to route intercooler pipe with...........
#1
Junior Member
Thread Starter
iTrader: (1)
Join Date: Nov 2006
Location: Hartville, OH
Posts: 173
Total Cats: 0
what is easy way to route intercooler pipe with...........
i've noticed alot of u don't have ps or ac or neither. routing intercooler pipe looks easy without ac or ps.
i have ac and ps, and i like them. however i'm stuck with the problem as to how to get the intercooler pipe out in front then back to tb. i have all of these ac lines, ac compressor, coolant lines, ps pump, and power steering lines in my way. i don't want to go under radiator(mite get smashed), bad roads in ohio. i like to go around rad but lots of lines running here or there. over the top seems simplest, but i would have to fab up special wide and flat pipe, and that seems like a lot of work.
i'm sure there is some kit out there, but i want to diy(suppose to be fun). i have searched threads but havn't found satisfying solutions.
kick my *** in the right direction
i have ac and ps, and i like them. however i'm stuck with the problem as to how to get the intercooler pipe out in front then back to tb. i have all of these ac lines, ac compressor, coolant lines, ps pump, and power steering lines in my way. i don't want to go under radiator(mite get smashed), bad roads in ohio. i like to go around rad but lots of lines running here or there. over the top seems simplest, but i would have to fab up special wide and flat pipe, and that seems like a lot of work.
i'm sure there is some kit out there, but i want to diy(suppose to be fun). i have searched threads but havn't found satisfying solutions.
kick my *** in the right direction
#2
if you look close, a lot of guys that go over the top, fab radiator mounts that move the top of the radiator toward the engine by about 3 inches, this gives you room to run the pipes up and over the radiator, and have lots of hood clearance. You will have to fap a place that spans the gap from the cross par to the front of the radiator to keep air from just going up and over the radiator unsted of through it. Or you can buy one, i think track dog may make one.
#13
Former Vendor
iTrader: (8)
Join Date: Mar 2005
Location: Broken Arrow,Ok
Posts: 1,185
Total Cats: 57
I wouldn't advise going under the radiator, but around the radiator will work just fine. To get the Intercooler to fit, you will probably need to massage some AC lines and the dryer (big aluminum can). Then just route it down next to the sway bar and into the IC, then go around the rad again and back up to the TB.
-Michael-
-Michael-
Thread
Thread Starter
Forum
Replies
Last Post
StratoBlue1109
Miata parts for sale/trade
21
09-30-2018 01:09 PM