exhaust manifold question...
#25
m
Yea mod already cleaned it up once would rather not lose the useful posts now
here is a useful post
me under your desk while you work. - m4m
me under your desk while you work. - m4m
#26
Very true I was thinking more along the lines of a eclipse 2.0t manifold but the best part is if I get it for next to nothing and it doesn't work..no harm no fowl I just wasted a couple hours,right? I'm not in any way saying it will work just weighing my options for manifolds...
#28
Seeing if the port spacing lines up is free.
Better yet, here it is from my 2G (DSM) mani:
Ports are almost exactly 2" across. Maybe another 32nd or so. Space between ports is approximately 1 and 9/16". Ports are about 1 and 3/16" tall.
So in order to shut this topic up as everyone wants to, someone measure a BP mani and lets us know that its totaly different.
Better yet, here it is from my 2G (DSM) mani:
Ports are almost exactly 2" across. Maybe another 32nd or so. Space between ports is approximately 1 and 9/16". Ports are about 1 and 3/16" tall.
So in order to shut this topic up as everyone wants to, someone measure a BP mani and lets us know that its totaly different.
Last edited by Sparetire; 03-26-2010 at 11:59 AM.
#30
Google works better from a different computer...or I suck at searching.
Anyway, here is a jpg of the BP flange:
https://www.miataturbo.net/forum/att...ust-flange.jpg
The ports are 1.89, which will work OK with the DSM ports. The BP ports are 1.18, which also works well to the 1 and 3/16 of the DSM ports. Some matching with a die grinder and you are in business there. The diagram seems to indicate a port sapcing of about 3" on-center, where the DSM is right around 2.5" I am not sure I am reading that right though.
I will check bolt holes, but my guess is that it will fit well with some slotted holes and port-matching.
Anyway, here is a jpg of the BP flange:
https://www.miataturbo.net/forum/att...ust-flange.jpg
The ports are 1.89, which will work OK with the DSM ports. The BP ports are 1.18, which also works well to the 1 and 3/16 of the DSM ports. Some matching with a die grinder and you are in business there. The diagram seems to indicate a port sapcing of about 3" on-center, where the DSM is right around 2.5" I am not sure I am reading that right though.
I will check bolt holes, but my guess is that it will fit well with some slotted holes and port-matching.
Thread
Thread Starter
Forum
Replies
Last Post