1999 Possible boost soon
11-15-2007, 08:34 PM
#1
Junior Member
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: So Cal
Posts: 322
Total Cats: 0
1999 Possible boost soon
Hi everyone, this is my first topic for this forum. I have a 1999 and I am planning on purchasing the new Begi system, but I want to make sure I have it all down. I am pretty good with FI, "study from Maximum boost
", but I am new to miatas. I know I have a returnless system, but I am wondering what I need to purchase along with the kit. If I go with emanage blue, and a set of higher cc injectors "junkyard FTW", will I be ok? What else is needed with this kit that is mandatory so my Daily driven baby wont explode. I plan on only boosting @ first 6-8 and adding a IC later on down the road. Basically I am just wondering if the higher rate injectors and emanage along with the kit will have me set for now. Thanks for the help and heres a picture. http://i170.photobucket.com/albums/u...y/IMG_0711.jpg
Thanks
", but I am new to miatas. I know I have a returnless system, but I am wondering what I need to purchase along with the kit. If I go with emanage blue, and a set of higher cc injectors "junkyard FTW", will I be ok? What else is needed with this kit that is mandatory so my Daily driven baby wont explode. I plan on only boosting @ first 6-8 and adding a IC later on down the road. Basically I am just wondering if the higher rate injectors and emanage along with the kit will have me set for now. Thanks for the help and heres a picture. http://i170.photobucket.com/albums/u...y/IMG_0711.jpgThanks
Reply
0
0
11-15-2007, 08:49 PM
#2
Supporting Vendor
iTrader: (33)
Join Date: Jul 2006
Location: atlanta-ish
Posts: 12,659
Total Cats: 134
Yup, a BEGi-S + EMB (or other capable piggy) + 300 cc injectors should do you fine to 6 psi. But no more until you get an intercooler. You 'll want a wideband as well.
Junkyard injectors FTL. Get a couple spares and have them tested and serviced before installation, and use the best 4.
Junkyard injectors FTL. Get a couple spares and have them tested and serviced before installation, and use the best 4.
Reply
0
0
11-16-2007, 10:47 AM
#3
Junior Member
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: So Cal
Posts: 322
Total Cats: 0
Yup, a BEGi-S + EMB (or other capable piggy) + 300 cc injectors should do you fine to 6 psi. But no more until you get an intercooler. You 'll want a wideband as well.
Junkyard injectors FTL. Get a couple spares and have them tested and serviced before installation, and use the best 4.
Junkyard injectors FTL. Get a couple spares and have them tested and serviced before installation, and use the best 4.
Reply
0
0
11-16-2007, 01:16 PM
#4
Junior Member
Thread Starter
iTrader: (6)
Join Date: Oct 2007
Location: So Cal
Posts: 322
Total Cats: 0
Also I just want to make sure, since I will be running piggyback, I will not need the Begi-S + returnless fuel upgrade correct? Because the returnless is just to help out an FMU work properly correct? Sorry if my information is bad. Thanks
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
