Problems with panel meter wideband gauge.
#1
Problems with panel meter wideband gauge.
What am I doing wrong here? Ive got it set up to read as 10:1 as 1v and 19.99:1 as 2v but the output 2 wire is only putting out .04 (confirmed with volt meter)
The wideband is reading correctly on output 1 and in logworks but just cant get the wire for the gauge to work right. (gauge reads 1.2v as 12v)
Any ideas?
#3
I tested it, it's putting out 3 something at idle I believe? Idk it's working properly but didn't want to unwire the megasquirt.
http://www.ebay.com/itm/Mini-99-9VDC...#ht_5874wt_897
Just sent the seller an email and asked for decimal to be adjusted. They have great cust service, it just takes a couple weeks for shipping
http://www.ebay.com/itm/Mini-99-9VDC...#ht_5874wt_897
Just sent the seller an email and asked for decimal to be adjusted. They have great cust service, it just takes a couple weeks for shipping
#4
Sooo... bringing this back from the dead. Would there be any harm in attaching the display to the working output and just setting the main output to 1-2v=10-20 afr and just telling the ms to use that? I noticed that in tunerstudio there is an option for "innovate 1.0-2.0" would this possibly be the same thing?
Thread
Thread Starter
Forum
Replies
Last Post