custom intake manifold?
#3
Heh... I'll have to check material thickness... but the same manifold on my friends 2.2L honda running 12psi and maxing out 780cc injectors... hasn't cracked/exploded it yet.
Baseplate is quite thick... billet AL. The pieces cut from a 90degree bend are .063 I think and the side plates are probably .08x something. Vacuum fittings are threaded into thicker plate added on top of bottom plate.
Beyond that... once I'm up and running... and boosting... I can tell you if it holds
Baseplate is quite thick... billet AL. The pieces cut from a 90degree bend are .063 I think and the side plates are probably .08x something. Vacuum fittings are threaded into thicker plate added on top of bottom plate.
Beyond that... once I'm up and running... and boosting... I can tell you if it holds
Thread
Thread Starter
Forum
Replies
Last Post