IC piping
#1
Elite Member
Thread Starter
iTrader: (24)
Join Date: Dec 2007
Location: Carrollton TX
Posts: 1,709
Total Cats: 15
IC piping
Is anyone running this style intercooler pipe setup? Looks nice and simple and short, with very few bends & couplers. I know their kits are for SC'd Miata's, but I don't see why you couldn't DIY a similar turbo system.
C
C
#4
Elite Member
Thread Starter
iTrader: (24)
Join Date: Dec 2007
Location: Carrollton TX
Posts: 1,709
Total Cats: 15
Originally Posted by ray_sir_6
www.trackdogracing.com
They do them for turbos, too.
They do them for turbos, too.
C
#10
No no it wasnt that hard.
You have to be able to weld (or know someone who can)
You cut the rad brackets and weld them about 1.5 inches lower (check this with the rad fans because of the front sway bar)
Then run your pipes and cut the hood a little bit. MAKE SURE YOU GET A INTERCOOLER WITH OUTLETS ON THE SAME SIDE!!
You have to be able to weld (or know someone who can)
You cut the rad brackets and weld them about 1.5 inches lower (check this with the rad fans because of the front sway bar)
Then run your pipes and cut the hood a little bit. MAKE SURE YOU GET A INTERCOOLER WITH OUTLETS ON THE SAME SIDE!!