LM programmer problem?
#1
Junior Member
Thread Starter
iTrader: (3)
Join Date: Nov 2006
Location: Omaha,NE
Posts: 46
Total Cats: 0
LM programmer problem?
I'm sure this question has already came up before,
so feel free to say the usual "Search" response if you must.
I did do some searching, but I didn't spend my usual 5 hours searching for this one. Just not in the mood.
My LC-1 gauge has been reading 22.4 when I'm in gear and off throttle(that's a whole different question I actually will do some research on),
but I set my LM programmer for 0-5v = 10-20afr for both outputs. Wouldn't that mean the max my gauge would show is 20:1 ?
Well I got on LM programmer and click the "Use AFR" button and type 10 & 20 on in the appropriate box on each tab and hit program. Then if I open it again both output tabs are back on the "Use lambda" button.
I already downgraded to the 1.0 firmware thinking that might solve the problem, but the same thing happens...
Is this supposed to happen ?
Thanks for your time!
so feel free to say the usual "Search" response if you must.
I did do some searching, but I didn't spend my usual 5 hours searching for this one. Just not in the mood.
My LC-1 gauge has been reading 22.4 when I'm in gear and off throttle(that's a whole different question I actually will do some research on),
but I set my LM programmer for 0-5v = 10-20afr for both outputs. Wouldn't that mean the max my gauge would show is 20:1 ?
Well I got on LM programmer and click the "Use AFR" button and type 10 & 20 on in the appropriate box on each tab and hit program. Then if I open it again both output tabs are back on the "Use lambda" button.
I already downgraded to the 1.0 firmware thinking that might solve the problem, but the same thing happens...
Is this supposed to happen ?
Thanks for your time!
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM