whinin

Gay being not straight.

Ok I pulled my manifold and trubo off and am checking to see if I need to get it machined. What do you guys think? Personally I think if I can see light through a straight edge it needs it, but I'm not sure if it would seal up once it gets warm.












Also, where on this manifold do I need to make my relief cuts? Between 1-2 2-3 3-4 or just 1-2 3-4?






Thanks!

concealer404

iTrader: (3)

That's pretty maximum.

Machine it.

curly

iTrader: (25)

What he said.

Cutting between 1&2 and 3&4 worked for me, although 2&3 wouldn't hurt.

18psi

iTrader: (76)

Definitely machine it flat.

Reverant

iTrader: (10)

Definitely gay.

whinin

Thanks you gays!

FRT_Fun

iTrader: (19)

This thread is too gay for me.

thenuge26

iTrader: (2)

I think it was Savington or Turbo Tim who, when asked about the tolerances for the manifold to turbo surface, said .00 was flat.

flounder

This is probably pushing the limit.

whinin

So I found out my straight edge wasn't so straight, which one of you got a hold of it? Waiting to get one that hasn't been tarnished.

zoomazoomzoom

Glad you found out before you were trapped in a marriage with a buncha kids.