OK something else broke
05-30-2010, 02:16 PM
#1
OK something else broke
My good damn oil feed fitting broke on me. I believe it is m10*1.25 to 4 an anyone know where i can get one that isnt alluminum the threads on the an side just desintigrated on my when i went to tighten it after i noticed some leaking. this damn car is so close but at the last second it fights me lol.,
Reply
0
0
05-31-2010, 01:49 PM
#3
Boost Pope
iTrader: (8)
Join Date: Sep 2005
Location: Chicago. (The less-murder part.)
Posts: 33,026
Total Cats: 6,592
I MIGHT be wrong here, but I thought that the fitting on the block was M10x1.5, not M10x1.25.
I do recall that when I was doing my original setup, I never was able to find a straight fitting to go into the block and give me an AN outlet. So instead, I used a brake banjo fitting. They're available in both straight & angled, and while I can't remember exactly which one I used, the gist was something like this with one of these screwed into it. (Don't forget the washers.)
Yeah, it's -3AN instead of -4. Works fine.
I do recall that when I was doing my original setup, I never was able to find a straight fitting to go into the block and give me an AN outlet. So instead, I used a brake banjo fitting. They're available in both straight & angled, and while I can't remember exactly which one I used, the gist was something like this with one of these screwed into it. (Don't forget the washers.)
Yeah, it's -3AN instead of -4. Works fine.
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
