y8s

iTrader: (8)

ok so the short version is "I want to try a smaller compressor".

the long version is:

will a 60mm 62 trim wheel and housing bolt to my 2876R's CHRA?

I haven't looked much at how it fits up yet but I'm hoping for an easy swap. whee!

oh and I think that this will make it a GT2860R. If that helps.

johndoe

iTrader: (5)

I have nothing of value to add but why do you want to go smaller?

Arkmage

iTrader: (3)

his dick got bigger, so their is no need to run an excessively over sized turbo for his power level?

y8s

iTrader: (8)

If paul is pulling 300 rwhp on a 2560 and has boost in the low 2000 rpms.... why the heck not?

I'm sure it's not an expensive test and may allow more smoky burnouts.

JasonC SBB

Teehee m@, didn't I always advocate the "smallest turbo for your realistic max hp goal", for a street car?

Braineack

iTrader: (62)

i don't see why it wouldn't work....so long as the housing is made for the wheel.

...the backplate will be machined for your 71mm wheel, but i don't see that posing an issue. you'll just have a 5.5mm dead space around the wheel.



you can see my backing plate...if you can't understand my jibber jabber.

Braineack

iTrader: (62)

hell dude, for the price, just buy this:

http://cgi.ebay.com/ebaymotors/T3-SU...mZ380050836442


then give me the turbine housing and wheel