josh90miata

have papers where it was rebuilt at around 140,000 miles
im going to check compression and make sure its a good engine tomorrow

racing beat side skirt, fenders, new top, red leather interior, adjustable cam gears, and its a LOT slower than my 93 that had the 1.8 swap in it.
i dont know why, it has full adjustable suspension, lowering springs, has a lot of stuff done

racing beat maf and racing beat intake, rx7 spoiler,



just some basic info about it ^^


but i want to just run 4-5 pounds of boost and i would be happy, just want something thatll give me a little more power and make it a little more fun to drive

so turbo mani/downpiep/turbo and pipe to intake ild imagine

whats cheapest build i can do? any advise, never had a turbo car before

chpmnsws6

iTrader: (12)

My single best piece of advice- delete this thread and read up for a few weeks.

If you don't, they will rape you like a house cat in here.

gearhead_318

iTrader: (1)

I made a similar thread not too long ago (albeit I wasn't afraid of the shift button, it wasn't my 1st post, I bothered to read up before posting, and I asked more specific well thought out questions), but they still ate me alive. They told me to do myself a favor and get the Begi-S kit, they will tell you to do the same.
Here is a link to the thread I made asking the same basic question:
https://www.miataturbo.net/showthrea...ght=obligatory

pusha

iTrader: (5)

For your own sake, I am doing this right now:

miatamike203

OP don't post back in this thread go to the noob section and post up. Then do a **** load of searching. If you keep at this rate they will ban you or you will get your *** put in your mouth by Hustler or one of the other noob PWNing members.

YOU HAVE BEEN WARNED!!!!

Bond

iTrader: (6)

Yes moar reading for the OP.

I can't believe I was the last one to post in that thread by gearhead.

josh90miata

oh schnap!! lol

where can i do some research at, any sections on this forum?

with used parts whats the cheapest build youve seen?

gearhead_318

iTrader: (1)

Read the stickies, in fact read all the stickies on this sight.

The aforementioned Begi-S is cheap and meets your goals.

No, you can not get an ebay kit that will work, and I highly doubt you could do a DIY kit that would be cheaper and not kill your engine.

Edit: Maybe the Shanghai-S would work:
http://www.bellengineering.net/produ...roducts_id=396