couple of questions
04-18-2013, 04:50 PM
#1
Junior Member
Thread Starter
iTrader: (4)
Join Date: Jan 2013
Location: Fort Myers,FL
Posts: 156
Total Cats: 1
couple of questions
so i derped and bought a -3an oil supply line yay for correct size, problem is it doesnt have a 90 degree end for attachment to the block can i still use this or will i have to source another.
Also, the internal wastegate actuator was removed on my turbo and so im not sure where im supposed to put the vacuum line from the actuator, i thought it was supposed to go on a nipple on the turbo, however i can not find anything
Also, the internal wastegate actuator was removed on my turbo and so im not sure where im supposed to put the vacuum line from the actuator, i thought it was supposed to go on a nipple on the turbo, however i can not find anything
Reply
0
0
04-21-2013, 12:39 AM
#2
Newb
Join Date: Mar 2013
Posts: 36
Total Cats: -14
On my last car, i didn't have a nipple on the turbo for a vaccum line, so i just welded a nipple as close as i could to the compressor on my intercooler piping. It worked great like that. However, i was using an external wastegate, not 100% sure it's the same, but i don't see why it'd be any different.
Reply
-1
-1
04-23-2013, 01:02 AM
#3
Junior Member
Thread Starter
iTrader: (4)
Join Date: Jan 2013
Location: Fort Myers,FL
Posts: 156
Total Cats: 1
well good news is i was reading up on a build thread and a guy mentioned Joe Perez's boost sag thread, so turns out it doesnt matter that i dont have the stock nipple
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
Greasyman
General Miata Chat
2
09-28-2015 10:44 AM
