Timing map help on EMB with pressure sensor
#1
!!! NOT CONFIRMED !!!
Thread Starter
Join Date: Nov 2007
Location: Virginia Beach, Va
Posts: 158
Total Cats: 1
Timing map help on EMB with pressure sensor
I bought a Greddy Pressure that I'am going to install on my EMB so I can pull timing under boost. (now using TPS not the best way) I'am going to be running 11 -12 psi does anyone have a EMB timing map based on that boost level so I can get a idea how to set it up ?
Thanks
current setup
1999 Miata
360cc GTX injectors
Garrett T-25 .48/.49 (saab turbo)
Emanage Blue
FM 0/2 clamp
current A/F 11-11.5 wot @ 70% duty cycle
Base timing is 12* pulling 6* by wot
on 10psi boost (no knock)
Thanks
current setup
1999 Miata
360cc GTX injectors
Garrett T-25 .48/.49 (saab turbo)
Emanage Blue
FM 0/2 clamp
current A/F 11-11.5 wot @ 70% duty cycle
Base timing is 12* pulling 6* by wot
on 10psi boost (no knock)
#2
start pulling 1 degree of timing for every PSI your running starting at 2 psi.
Then at 6000-6400 rpm add back in 1 degree per psi
then at 6500+ add another 1 degree in.
between 2500-3000 add in one degree per psi and again another between 2000-2500 and another at 1500-2000.
its sounds a bit messy but once you have the timing map infront its easy to set up.
Then at 6000-6400 rpm add back in 1 degree per psi
then at 6500+ add another 1 degree in.
between 2500-3000 add in one degree per psi and again another between 2000-2500 and another at 1500-2000.
its sounds a bit messy but once you have the timing map infront its easy to set up.
Thread
Thread Starter
Forum
Replies
Last Post
Motorsport-Electronics
ECUs and Tuning
0
09-05-2015 08:02 AM