Emanage advice
05-17-2010, 04:45 PM
#1
Junior Member
Thread Starter
Join Date: May 2008
Location: Stafford - UK
Posts: 72
Total Cats: 0
Emanage advice
After getting the emanage repaired 
,evrythink now works as it should. The emanage has been set up using a base map from a similar set up to mine and I have now fitted it along with an O2 clamp. I have the actuator wired open on the supercharger and but still have the MSD fitted. I have a 150mm crank overlay and slightly larger Mk2.5 injectors fitted. I have a knock sensor on order and it should be here soon. once the knock sensor arrives, will I be okay to remove the MSD and start tuning? Is there anything else I need to look at?
I have a Uego Wideband sensor and guage fitted, but as I have a 3 bar map sensor I'm not sure yet how to log AfR's, can anyone advise?
,evrythink now works as it should. The emanage has been set up using a base map from a similar set up to mine and I have now fitted it along with an O2 clamp. I have the actuator wired open on the supercharger and but still have the MSD fitted. I have a 150mm crank overlay and slightly larger Mk2.5 injectors fitted. I have a knock sensor on order and it should be here soon. once the knock sensor arrives, will I be okay to remove the MSD and start tuning? Is there anything else I need to look at? I have a Uego Wideband sensor and guage fitted, but as I have a 3 bar map sensor I'm not sure yet how to log AfR's, can anyone advise?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
