olderguy

iTrader: (19)

For those that know there way around their computer, here is a quick way to go to "Gold" Emanage software.

Your support tool probably loaded into

C:\Program Files\TRUST\GReddy e-manage support tool

If you remove the old files from the folder, unzip these attached files and put them in the folder to replace the removed files, you should be able to start your support tool as you normally do and now be in "Gold"

Note that it will work only if the support tool has already been installed on your computer.

Save your old files someplace that you can reconstruct if need be. I have done this on several installations now and it works fine, but just in case, keep your old files.

olderguy

iTrader: (19)

Will do the same for .149/.149 later

elderc

Olderguy,
If you are already running 1.49 whats the advanatage of running "Gold"
is that not a older program ? or does it have functions the 1.49 does'nt ?

olderguy

iTrader: (19)

Yes it is an older "Gold" program and some members were looking for it recently. See the date of the post. I haven't had a chance to pull out the .149/.149 files yet and post them.(portable computer that is not readily available)

olderguy

iTrader: (19)

This should do it.

dzaster

iTrader: (2)

So should the Gold 1.49 have and additional options that the Blue 1.49 may be lacking?

olderguy

iTrader: (19)

Upgrading the blue to .149/.149 just gives you some of the "Gold" options. It is a misnomer.

amagalla

iTrader: (2)

Let me confirm: upgrading a blue to 1.49/1.49 doesn't give you a EM Gold, but makes your blue "gold like". Is that right?

Tony

olderguy

iTrader: (19)

Upgrading the "Blue" gives you all of the software advantages, like TPS control of your additional injection. But there may be things you don't get unless you change the hardware. I never needed more than the software changes, so didn't pursue them.

The .125/.147 upgrade at the top of this thread accomplished all I wanted. The further upgrades were there, so I did them.

94blackmx5

i believe there is a hardware mod required for it to be a Gold

willyhua

hi ,my e-manage blue need modified hardware or not? if i upgrade this software? thank you very much to share this software...

arcangel1988

I have a question my eManage blue. you cut the pins to the chip. plus jumper you install the gold version is here that I get error my unit is not compatible with this software. thank you for your help

4sfed5

it was only the very very early versions that required the hardware mods. mine was built 2005 and it required no mods at all to upgrade to gold. just a firmware upgrade to 1.25/1.47 or above. im running the NVCS output to switch an o2 clamp relay and the sub injector output to fire an overboost/over rev light

arcangel1988

understood can not move to get error 1.25 1.47 eManage this unit is not supported for this version has cut the pins on the chip but the jumper wearing not that that happens to be very old