Campbellsouup

I'm just finishing up assembling my main board on my diypnp kit for my '96
Now that I am about to start putting in the microsquirt module and other final pieces I just want to clarify as to whether or not I need to use any of the optional parts that I was left with after assembling the main board:


I understand that these are optional pieces for vehicle-specific applications but can't seem to figure out whether or not i'm going to need to install any of these for my use, any insight would be appreciated.

I have an innovate wideband, gm aif sensor, and will be using the stock ignition coils

Campbellsouup

Also, I'm left with jumpers and shunts for boot, BL/TH, and OPTO GND, what are these for? The only things i see referencing them are older ms builds

dieselmiata

iTrader: (3)

There will be plenty of parts left over. DIY gives you enough that you can mess a few up, and to add components later on.

Campbellsouup

Okay cool, so I should be good, I went ahead and installed the jumpers but not the shunts so I can make the connections as needed.Also is the main board supposed to