My VE Table #'s are very lean in the middle rows

Reply Subscribe

Thread Tools

Search this Thread

10-05-2014, 11:12 PM

Baker99miata

Junior Member

Thread Starter

iTrader: (4)

Join Date: Jun 2013

Location: Dallas TX

Posts: 148

Total Cats: -3

My VE Table #'s are very lean in the middle rows

Attached are two different tunes that I have been working with running MS2. My car was running good on a 9900 base map. I then installed 440cc Injector and squaretop, reduced required fuel to between 7.0-9.0 But for some reason it is lean on the bottom rows (vacuum), and rich in the middle rows. Any advice would be greatly appreciated.

Attached Thumbnails

My VE Table #'s are very lean in the middle rows-v__ee33.jpg

Attached Files

okTune10-5-14.msq (84.8 KB, 247 views)

oktune440cc4Teeth7kRPM.msq (84.8 KB, 248 views)

10-06-2014, 12:12 AM

Baker99miata

Junior Member

Thread Starter

iTrader: (4)

Join Date: Jun 2013

Location: Dallas TX

Posts: 148

Total Cats: -3

Maybe I have a battery voltage calibration issue? or a leaking injector

Megasquirt Support Forum (MSEXTRA) • Battery correction. THe correct procedure? (View topic)

10-06-2014, 08:19 AM

Braineack

Boost Czar

iTrader: (62)

Join Date: May 2005

Location: Chantilly, VA

Posts: 79,493

Total Cats: 4,080

tune them not to be lean anymore.

10-06-2014, 08:50 AM

acedeuce802

Senior Member

iTrader: (1)

Join Date: Dec 2010

Location: Farmington Hills, MI

Posts: 1,218

Total Cats: 175

You expected new injectors and intake to require the same VE map? Injectors aren't perfectly linear, scaling for them will get you close, not perfect.