fastnfurious7

iTrader: (10)

I'm a noob to this forum, my car, & to turbo cars in general. I got my 1993 Miata with a unknown turbo on it. Kit looks DIY. Anyway, it has the Link Engine Management system & from the literature that came with it, it looks to be an older unit. I know absolutely nothing about the thing except what I read in the manual & since I don't know too much about these turbo cars...much of it might as well have been Greek. Here's the deal. The guy I got the car from said that he is running it in "safe" mode, whatever the hell that means. I guess from my reading he just did a RELOAD & set back to default settings. The car runs ok but if you stomp the throttle or if you rev it up much past 4K RPM it cuts out. Previous owner said he was running it with about 6 or 7 PSI boost & the boost gauge seems to comfirm this. Does anyone have a map I can run in this thing to stop this cutting out problem until such time that I can afford to properly tune this thing on the dyno? See, told you I was a Thanks in advance.

matttheniceguy

http://www.flyinmiata.com/support/in...ECU_tuning.pdf

Check out item 4 on page 6, sounds like there is either a problem with the intake air temp sensor or it is purposly disconnected.

If you want to figure out that car, you will have to learn a bit more, and read and understand that manual. Going through the initial car setup stuff again would be a good idea as well.

fastnfurious7

iTrader: (10)

Thanks for the reply, Matt. I did read that whole manual up to the more detailed stuff in Section 8. I will re-read it keeping in mind your suggestion about the intake air temp sensor. I also have not had a chance to try to set the car up because I have to recruit someone to help take notes in the passenger seat to do it. The other problem is that I don't know all of the mods on the car. I don't know what type or brand of turbo is on there. I also don't know which size injectors are in there. They say RC Racing (I think) on them but I don't know if they are the 440cc or the 550cc. Any easy way to find out? I am also assuming that the upgrades to the MiataLink system have been made but that also may not be the case. You are very correct, I need to learn a bunch more about the car to solve this problem. Any assistance on how to identify what I have on the vehicle will be greatly appreciated.

fastnfurious7

iTrader: (10)

Okay. I answered my own question on the injectors...DUH. They are either SL4-440's or SL4-550's. I don't have the car with me so I will take a look @ that when I get home on Tuesday. Obviously by my signature you can tell that I assumed that they were 440's but I need to check to make 100% sure. The PO did say that the injectors were already set up for sequential injection which is good.