LC-1 screenshots
#1
LC-1 screenshots
I hate to be a pain, but I'm having real problems getting me LC-1 to talk to my Megasquirt and NB AFR Gauge.
Can someone post screenshots of the configs for their outputs for talking to these?
I this AFR gauge:
The LC-1 shows good looking values, but on the Megasquirt they sit around 8-9 and never move. Do I need to do the resistor thing?
I'm about to pull up the carpet around the ECU to check the wiring too.
Can someone post screenshots of the configs for their outputs for talking to these?
I this AFR gauge:
The LC-1 shows good looking values, but on the Megasquirt they sit around 8-9 and never move. Do I need to do the resistor thing?
I'm about to pull up the carpet around the ECU to check the wiring too.
#3
I hate to be a pain, but I'm having real problems getting me LC-1 to talk to my Megasquirt and NB AFR Gauge.
Can someone post screenshots of the configs for their outputs for talking to these?
The LC-1 shows good looking values, but on the Megasquirt they sit around 8-9 and never move. Do I need to do the resistor thing?
I'm about to pull up the carpet around the ECU to check the wiring too.
Can someone post screenshots of the configs for their outputs for talking to these?
The LC-1 shows good looking values, but on the Megasquirt they sit around 8-9 and never move. Do I need to do the resistor thing?
I'm about to pull up the carpet around the ECU to check the wiring too.
#5
Boost Czar
iTrader: (62)
Join Date: May 2005
Location: Chantilly, VA
Posts: 79,493
Total Cats: 4,080
IIRC, I have my outputting from 0-1v a scale of 18:1 - 10:1 (this is output the 20 LED gauges are scaled to be at with a NB gauge)
The output2 for the MS has a 0-5v 10-20:1 input. You need to make sure the MS is looking for a 5v signal not a 1v one....see basic settings, exhaust gas settings. change narrowband to wideband and the step size to 2.35v.
The output2 for the MS has a 0-5v 10-20:1 input. You need to make sure the MS is looking for a 5v signal not a 1v one....see basic settings, exhaust gas settings. change narrowband to wideband and the step size to 2.35v.
Thread
Thread Starter
Forum
Replies
Last Post