matredd

iTrader: (1)

I have an mp62 with the 62.5mm pulley pushing about 9-10psi. I have RX8 flow matched injectors and a Walbro 190lph. No matter what I do with the MAF table it seems that I cannot get fuel added above 7psi. It goes from a good 12.2 to 14.5.

I'm using .945 for the MAF scaling and have used values anywhere from -7 to positive 29 and it still reads lean on my UEGO.

Any ideas?

Side note: My idle, set anywhere from 0 - 5 degrees advance with fuel from
-5 to +5 I see AFRs jumping everywhere from 11 to 18. I noticed with my ODBII scanner that my timing was at 2,5,7,14,3,5... at idle even though xmap shows constant.

I recently replaced my CAS and i'm seeing the exact same activity. I've tried different coils, wires, and plugs as well.

saedrin

iTrader: (2)

Have you tried the XEDE files I uploaded a while back?

http://www.mediafire.com/?r3m9wpn8bzkckaz

Try this fuel map and see if your AFR is more manageable.

Edit: about the jumpy idle, I had a similar issue for a while. You need to make sure that you drive the car for a while on a specific map for the trims to level out. After a day or two my idle smoothed out to around ~14-15 AFR and my boost AFR stayed ~12-11.5 AFR

romanservices

I know this is an old post but can you send me your maps? the lin no longer works

Thanks

zer0cool

this

romanservices

This what?

chriscar

iTrader: (24)

this is a noob spamming his way to meet the minimum post count so he can sell his hoopty.

C

zer0cool

Lol hoopty you wish bro.

chriscar

iTrader: (24)

Your spray bombed stock wheels and cracked body kit say otherwise. Regardless, stop with the bullshit posts.

C