tplociniak

iTrader: (3)

How does the tps mount to the plate? How does it detect the throttle position, I am not comprehending this, also my sensor slides over the throttle shaft without needing to file anything to fit like the "how-to" states.

Should the tps rotate with the throttle shaft?

Does washer/post combo need to be cut off so the tps can sit flush on that mounting plate?

Is that yellow plastic collar piece required in the right side of the photo?

Braineack

iTrader: (62)

mine.

tplociniak

iTrader: (3)

Your photo shows a "D" type opening that keys into the throttle shaft which I do not have. I am still unsure how this reads the position, it appears yours is mounted on top of that post where the old plastic mounted was mounted (shown in second photo), is that correct?

Braineack

iTrader: (62)

mine's not the same Wells are yours.








I need to find the one ggreg used and update the post with that. it has the correct shaft key like the one i edned up with.

Notice on Ben's writeup that you need to shave the center to fit the TB's "D-shaped shaft...

tplociniak

iTrader: (3)

I read that, but my opening is large enough that the shaft slides through without needing to file anything, that is also where I am confused.

Braineack

iTrader: (62)

maybe the design has changed? or you didnt get the 201 and got the 210 like in thread title??

tplociniak

iTrader: (3)

I ordered the 210 like it says in the instructions

Braineack

iTrader: (62)

look at the picture in your first post.

tplociniak

iTrader: (3)

Guess I should have read through the link in the instructions closer before ordering...

Braineack

iTrader: (62)

im dylsexic. sorry about that.


find the WELLS TPS that ggreg ended up with, he posted it here somewhere. that's the one to score.

tplociniak

iTrader: (3)

no you tell me...

no problem, what is ggreg's name on here so I can search for his post, wells tps only seems to return my two posts

Braineack

iTrader: (62)

search function is dead. hold on, ill find it.

Braineack

iTrader: (62)

https://www.miataturbo.net/megasquir...45/#post738986

http://www.farnell.com/datasheets/26181.pdf

tplociniak

iTrader: (3)

Thanks, too bad the ebay seller I purchased the wells tps from only does exchanges and not refunds

tplociniak

iTrader: (3)

And it turns out that sensor is no longer manufactured

djtc

If you can't find the Wells anymore then you could try Standard th56.I cross referenced the Wells part number and the th56 is the alternative.Looks almost the same to me!

tplociniak

iTrader: (3)

Ended up using the tps210, see my link below for how I mounted it

https://www.miataturbo.net/megasquir...install-67899/

BTMiata

iTrader: (5)

Ancient thread... But I am attempting to get some stuff installed today and my Wells TPS is on my list. Will this thing work with the stock ECU? I'm doing this at my work's garage and if I cant get up and running on my MS I will have to swap back to the stock ECU to get home.

Harv

iTrader: (4)

Pretty sure that's a no.

BTMiata

iTrader: (5)

Yeah thats pretty much what I was thinking, but figured it was worth asking. Look's like I am going to have to wait till I have a few day stretch where I wont be SOL if I can't get my car to run. Maybe i'll pick up a spare stock TPS...Hmm