Your opinions on my WBO2 readings
#1
Your opinions on my WBO2 readings
Ok, I obviously started a complete **** thread earlier, and I replied to it adding this question to avoid starting a new one. No one appears to revisit the old one though, and I'm worried that I could screw up my car.
I needed to graph my auxCF input in order to see the A/F graph (a conversion has to be done). After doing this though I'm having an issue with the readings that i see. At idle it appears to be very rich (between 8 and 9), but throughout the map it will shoot back up to 19.44, then start reading correctly intermittently throughout the map. I'm wondering what is going on? Under boost it will show that the A/f is close to target. Does anyone have an idea as to why the A/F reading would be like this? I have an AEM wideband o2 without gauge. Could the o2 sensor be going bad? If anyone has or had this issue, please respond.
I needed to graph my auxCF input in order to see the A/F graph (a conversion has to be done). After doing this though I'm having an issue with the readings that i see. At idle it appears to be very rich (between 8 and 9), but throughout the map it will shoot back up to 19.44, then start reading correctly intermittently throughout the map. I'm wondering what is going on? Under boost it will show that the A/f is close to target. Does anyone have an idea as to why the A/F reading would be like this? I have an AEM wideband o2 without gauge. Could the o2 sensor be going bad? If anyone has or had this issue, please respond.
Thread
Thread Starter
Forum
Replies
Last Post
Zaphod
MEGAsquirt
47
10-26-2018 11:00 PM
stoves
Suspension, Brakes, Drivetrain
5
04-21-2016 03:00 PM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM