DanBrown

iTrader: (1)

Alright, before any of you say "Just research it", I've looked all over the internet trying to find the right pin out for this damn connector.
When I ask this question, IGNORE COLORS. I do not have the exact pigtail that came with the VTPS, I have one that fits, but has different colored wires.
The pin out for the non-variable TPS is as follows:

Now, can anyone show the corresponding information but on the A/T VTPS?



The model number is JE50 18 911

Braineack

iTrader: (62)

what year miata? I'm assuming 1.6L here?

DanBrown

iTrader: (1)

Yep its going on a 1.6L

DanBrown

iTrader: (1)

sorry its a 1990, if that makes a difference

deezums

iTrader: (3)

Does this help? From top to bottom should be 5V ref, TPS Signal, open pin, Signal ground.

Wiring Up An Auto Vtps - Forced Induction & N/A Power Mods - MX5Nutz Forum

DanBrown

iTrader: (1)

This picture would help a lot if I knew which wire doesn't get used and if i could see the colors more clearly. (Middle two both look the same)

deezums

iTrader: (3)

The wire labeled idle switch in that picture is unused.

What do colors matter, didn't you say so yourself? There's plenty in that picture to get you going.

Braineack

iTrader: (62)

I used to have the perfect image, but its no longer online.

just look at the 92 service manual:

http://www.miataforumz.com/1990-200-...Manual1992.pdf

the wiring diagram section shows the pinout and wire colors.





1N (R) is on/off idle switch
B/LG is Ground
LG/R is 5V
2M (R/B) is vTPS signal

DanBrown

iTrader: (1)

This is perfect, thanks guys. I had a schematics from the haynes manual but it was wrong when it came to the wire colors on the TPS for the 1.6, so I couldnt trust it.

And yes the colors didnt matter if someone was just telling me the pin out, but with the picture I could do some simple translating and understand which colors they were talking about. Anyway, Thanks again.