redturbomiata

iTrader: (5)

the engine in my car is still on the original injectors, and ecu. i want to add 460cc injectors and a mspnp. i have a intercooled greddy kit that runs 5-7psi if i add these two pieces what can i expect to be able to run.

fooger03

iTrader: (2)

Pearl red, but only if you've got black or silver wheels. You might be able to get away with a candy, but I've only seen a few people do it right.

MartinezA92

iTrader: (4)

900 whp depending on the weather and how much your girlfriend weighs.

If you had done a search for "fat gf", you'd know this.

samnavy

iTrader: (7)

Post more info about your setup... EVERY SINGLE PART, down to the clamps and nuts/bolts.

Bond

iTrader: (6)

460cc should be good to 240whp with a greddy I think. The calculator is in the FAQ.

v01canic

iTrader: (1)

fucked up but i

redturbomiata

iTrader: (5)

stock 92 motor, stock ecu, greddy td04h-15g, big *** ebay intercooler, and cold air intake thats not so cold.

RyanRaduechel

iTrader: (10)

Are you using a rrfpr? Or is it the stock fpr as well?

redturbomiata

iTrader: (5)

forgot to mention msd boost control box, and vortech fmu.

Joe Perez

iTrader: (8)

More power than the puny little TD04H-15G turbo that came in your Greddy kit is capable of maintaining airflow to support.


The MSD box must obviously be removed, and preferably cast into a lake of flaming sulfur. The Vortech may be left in place, or removed at your discretion. Its presence will alter the scaling of the fuel map considerably, so you'd be unable to use anybody else's fuel map as a baseline.

samnavy

iTrader: (7)

I'm trying to identify the weakest link in your system to making power. I know of a few Greddy setups who've pushed the 250whp mark... but they had aftermarket DP's 3" DP's, headwork, full supporting mods, etc...

If you're still on the stock Greddy downpipe, I don't think I've ever heard anyboyd make more than about 180whp on one, that's why I asked for every single part. If you're on stock hose clamps and not T-bolt clamps, you'll be limited to how much boost you can run, for example.

Can you be more specific about your setup? Maybe some pics?

redturbomiata

iTrader: (5)

redturbomiata

iTrader: (5)

unfortunately i have no idea what all was put into it. i didn't not d the work, i bought the car as you see it. so im clueless.

fooger03

iTrader: (2)

Then I shall give you a clue.

Clue: Put your location in your profile.

redturbomiata

iTrader: (5)

you wouldnt happen to be a member of the Buckeye Miata Club would you.

soviet

iTrader: (10)

you should expect to run ALL OF IT. whatever boost your turbo makes, that is.

samnavy

iTrader: (7)

I've seen worse.
You've got some standard hose clamps on your charge pipes... will need t-bolt clamps.

Probably still on the stock Greddy DP, will need aftermarket drop-in version. I know a few places make them, but you'll have to ask/look.

Run a test-pipe, 3" exhaust, new fuel filter... install 460's and MS, run 14psi of boost for about 220-230whp.

Wait for clutch to fry and replace.

Wait for differential to explode and replace.

Might want a new fuel pump, tranny and dif fluid swap, and a new radiator... I can tell from the color of your radiator that it's about to **** the bed.

Enjoy.

fooger03

iTrader: (2)

See, there you go. Now I know that you live like half an hour away from me, and I can offer to come halfway out and take a look-see, or you can drive it up here, whichever suits you.

I'm not a member, but I run one or 2 autocrosses with them a year.

redturbomiata

iTrader: (5)

Contact info sent in pm. whenever is good for you, as long as i dont work that night. somewhere in between sounds good to me.

Jpopsbronco

iTrader: (9)

Here, Allow me http://tinyurl.com/3ngjlb8