Planing for build, need advice
#1
Senior Member
Thread Starter
iTrader: (5)
Join Date: May 2011
Location: London,OH
Posts: 1,139
Total Cats: 13
Planing for build, need advice
So i am in the process of purchasing a 90 rolling chassis and a dissasembled 1.8 out of a 94. the body is suprisingly solid for an ohio car minimal rocker rust, so paint and a bit of work on that will sufice. The car is going to be mostly street, a few track events here and there, and some strip time.
The engine is alread dissasembled and awaiting machining. I want a higer horsepower motor, i want to be able to take my buddy in his new 5.0 stang.
Pickup a vvt head
Rods/pistons
Oversized valves?
Head studs
Headwork
Solid Lifters (do these work with factory cams?)
Upgraded oil pump
Good Bearings
Intake Manifold ( are the modded honda manifolds good for this application?)
Big Injectors
Fuel Pump
MS
are the turbo II trans adapters on the market yet?
Artech Manifold/DP V-band
would going bigger than the gt 2871r do me any good?
The engine is alread dissasembled and awaiting machining. I want a higer horsepower motor, i want to be able to take my buddy in his new 5.0 stang.
Pickup a vvt head
Rods/pistons
Oversized valves?
Head studs
Headwork
Solid Lifters (do these work with factory cams?)
Upgraded oil pump
Good Bearings
Intake Manifold ( are the modded honda manifolds good for this application?)
Big Injectors
Fuel Pump
MS
are the turbo II trans adapters on the market yet?
Artech Manifold/DP V-band
would going bigger than the gt 2871r do me any good?
Last edited by redturbomiata; 09-27-2012 at 10:55 AM.
Thread
Thread Starter
Forum
Replies
Last Post