v01canic

iTrader: (1)

Does anyone know if they make an oil cooler sandwich plate that has NPT fittings for sensors etc...

Did the following search with no luck: https://www.miataturbo.net/search.php?searchid=2482358

Thanks peeps

Mobius

iTrader: (2)

TVC-50 or TVC-60.

Ebay has cheaper alternatives; success rates vary with them. Note the full bypass TVC-60 is only good for sensors. Edit: I have been running the TVC-60 for 4 years with my oil temp/pressure sensors with no leaks or other issues.

MIH Performance billet oil control products

Sokool

iTrader: (1)

https://www.miataturbo.net/engine-pe...e2/#post911211

Zefiris

Heya Fady. I went with

Sandwich Plate - Mocal Sandwich Plate- 20mm Thread

It installed fine. I have a small oil leak, but I think that is because I didn't tighten up the hose fitting onto the plate quite enough. Still have to get under there and check it out.

v01canic

iTrader: (1)

Thanks Mr. Smithson, see you at Wilcox?

Savington

iTrader: (31)

FYI, the Mocal adapter fittings are 1/2" BSPP (British Pipe Parallel) and they should seal with Dowty seals, not on a taper. Leaks are pretty common if you use the wrong fittings there.

Zefiris

Yep, I actually have these on there - Mocal 1/2 BSP x -10 fitting

I think the leak is because of the location. Hard to get a wrench in there to put a lot of torque, so probably just limp wristing it.

Yep Fady, definitely will be at INDE. If the car runs right, maybe you can take it out for a spin. Thought we had more time at that P1 track last time.

v01canic

iTrader: (1)

let me know if you need a hand getting it running right. Just dropped mine off at the body shop yesterday. Wish me luck.

JasonC SBB

Lars has one for sale really cheap.

shuiend

iTrader: (24)

It is already gone, sending it out to Hustler so he can have something to worry about on his NA car now.