JasonC SBB

Like this poster from another forum says:

Chevelle Tech - View Single Post - 10.25:1 pistons for 71' 402

Anyone thought about this? Milling the rectangular pad or "dome" by 0.8 mm will reduce c/r from 10:1 to 9.7, and by 1.8 mm will reduce it from 10:1 to 9.3. I wonder if the 10:1 pistons have more meat here than the 9.4 ('99) pistons.

Y8s, can you measure the thickness of the crown of the 99 pistons you have?

JasonC SBB

I measured the material thickness in the center of the crown of the 01 pistons .... ~ 4mm, yowza!

neogenesis2004

iTrader: (12)

How thick did you expect it to be? Thats the better question.

JasonC SBB

Hoping against hope that Mazda raised the c/r by thickening the crown.

vw_nut

iTrader: (1)

I was able to do this with good success on a vw 2.0 16v motor, but there may have been more meat to the piston tops. Droppedt from 10.8:1 to ~9.3:1 cr

Definately a cost effective option if you already have the pistons and there is enough meat in the piston to do this.

miatauser884

iTrader: (11)

I agree. If you already have the pistons. It might be cost effective if there is enough meat. I'd check with a machine shop first to see what they charge. Machine shops are generally not that cheap. It might end up being worth it to save for some forged pistons.

Has anyone checked to see if you can by a head shim for the mazda head. I know for my mopar 440 you can buy varying thicknesses of head gasket for this purpose.

Full_Tilt_Boogie

iTrader: (1)

you can, but thats the wrong way to lower compression, it can have effects on other things besides compression