cj9694

so admittedly I have no idea where the proper place to post this question. I'm wondering how this port is removed. Is it threaded or press fit? I don't need it on my race motor as all it does circulate hot coolant through the throttle body. I would like to use it as a port to put a temp sensor.

bahurd

iTrader: (8)

It's on the site somewhere but damn if I can figure out a search for it. Ask @aidandj for it. He posted it about 2 weeks ago +/-.

18psi

iTrader: (76)

press fit
see aidan's thread, it was a few days ago, so probably the last 1000-2000 pages

ramensoop

iTrader: (1)

Here is the thread

https://www.miataturbo.net/general-m...er-plug-92884/

i couldnt get it to hammer out so cut it flush and drilled it out in steps.

cj9694

What did you remove it for? Temp sensor?

cj9694

Also thanks a ton guys! The thread is funny to read.

ramensoop

iTrader: (1)

i just plugged it for now. Better than a rubber cap with jb weld and a hose clamp like i had on my old head.

Bonus that i have 1/2npt port if/when i replace the gauge cluster.