Sentic

iTrader: (1)

As above.

Car is already running 6speed and that starter on a bp4w and is controlled by ms3.

Looking to build a block beside the car.

Are all the sensors interchangeable / fit with my current harness between the 2 blocks, or do I need to rebuild harness / ms / change sensors?

Is the bpz3 head gasket recommended or is a bp4w hg with reroute the way to go?

Thanks a lot!

Schuyler

iTrader: (1)

<p>I'm about to run this exact setup. I am running the bp4w hg with a reroute, but I also already had the supplies for the reroute. It should all be the same.</p>

18psi

iTrader: (76)

same

Dunning Kruger Affect

The 99-00 and 01-05 should all have the same sensors. I think that the cam sensor moved, so you might need to extend the harness. You'll need to run 2 wires to control the VVT solenoid, as well.

Schuyler

iTrader: (1)

<p></p><p>He's running the bp4w head</p>

Dunning Kruger Affect

The 99-00 and 01-05 should all have the same sensors. I think that the cam sensor moved, so you might need to shorten the harness. You'll need to tuck away the 2 wires that control the VVT solenoid, as well.

Savington

iTrader: (31)

The blocks are externally identical for your purposes