question about using add-a-circuit
06-27-2008, 10:18 AM
#1
Elite Member
Thread Starter
iTrader: (5)
Join Date: Mar 2007
Location: NYC
Posts: 1,970
Total Cats: 1
question about using add-a-circuit
I'm going to try to wire up my LC-1 and MSPnP today
. I am going to use an add-a-circuit to get power for the gauge and controller.
#1 Do I use the same amp fuse that was originally there when I put in the add-a-circuit or one that is higher?
#2 Can I wire both gauge and controller to the same circuit or should I have an add-a-circuit for each?
thanks
. I am going to use an add-a-circuit to get power for the gauge and controller. #1 Do I use the same amp fuse that was originally there when I put in the add-a-circuit or one that is higher?
#2 Can I wire both gauge and controller to the same circuit or should I have an add-a-circuit for each?
thanks
Reply
0
0
06-27-2008, 10:29 AM
#2
Elite Member
Thread Starter
iTrader: (5)
Join Date: Mar 2007
Location: NYC
Posts: 1,970
Total Cats: 1
re-read some stuff about the add-a-circuit. Seems like a place the original fuse in one slot and another fuse for the stuff I'm adding in the slot closest to the wire. Would a 10A fuse be sufficient for the controller and gauge wired together?
Reply
0
0
Thread
Thread Starter
Forum
Replies
Last Post
bigmackloud
Miata parts for sale/trade
19
01-08-2021 11:24 AM
JesseTheNoob
DIY Turbo Discussion
15
09-30-2015 02:44 PM
