Can't get PS bracket off
#1
I EAT CUM
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Redneck, Texas
Posts: 1,198
Total Cats: 0
Can't get PS bracket off
I'm trying to remove the power steering and install the pulley so I can just use a/c but for the life of me I can't get the third bolt off of the ps bracket. It is covered up by the bracket itself and underneath is the water pump neck so I can't fit a wrench in there either. I tried cutting the bracket to get to the bolt but the dremmel stopped working halfway through the cut. Any ideas?
#2
Elite Member
iTrader: (7)
Join Date: Jan 2007
Location: Renton Washington
Posts: 1,731
Total Cats: 4
There's an insert that you can remove. Drift it out with a hammer and a punch. I personally didn't find this out untill I got it off turning the whole bracket to loosen the bolt then putting my finger to stop the bolt from spinning as I lifted the bracket off.( sort of like the process of using a ratchet)
#9
I EAT CUM
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Redneck, Texas
Posts: 1,198
Total Cats: 0
Well, when I get off work I'm going to see if I can rotate the bracket with a mallet or something. Otherwise it will be off to figuring wtf is up with my dremel. This is the second one to go out on me in 3 days. I don't know if I'm overheating these things or what.
#10
I EAT CUM
Thread Starter
iTrader: (6)
Join Date: Sep 2008
Location: Redneck, Texas
Posts: 1,198
Total Cats: 0
Just to update this thread, I did get the bracket off by hitting the corner with a hammer and it loosened the bolt just enough so I could remove it by hand. Now I just need a new dremmel so I can chop the lines.
Thread
Thread Starter
Forum
Replies
Last Post
chris101
Miata parts for sale/trade
2
10-09-2015 09:08 AM