miatauser884

iTrader: (11)

It's some sort of WG exhaust seperator

thagr81 us

iTrader: (5)

One came with a cheap turbine outlet tube I ordered off of eBay for my old SRed S14... Not sure where to get one by itself though.

18psi

iTrader: (76)

cut a piece of pipe out?

wayne_curr

iTrader: (8)

Get a bell mouth downpipe and dont worry about it anymore

NA6C-Guy

iTrader: (1)

+1

Piece of pipe 1/3 diameter, and a quick weld job. Profit.

miatauser884

iTrader: (11)

My **** is already on the car. I'm not messing around with pulling everyhting off. Plus, my DP has two nice threaded holes for one of these.

NA6C-Guy

iTrader: (1)

Well something is going to have to come off to get it on there anyway. I don't know how much luck you will have at finding one, at least one that will fit correctly without slight modification. I still say get someone to fabricate you one if you want it so badly. Otherwise, good luck.

miatauser884

iTrader: (11)

You can get them with an sr20 elbow on ebay for 60 bucks. I can get one on by disconnecting my dp from the turbo without removing it from the car.

Getting one machined will probably cost more than $60. Is the performance gain worth the cost?

I have a nice DP

NA6C-Guy

iTrader: (1)

You may can slide it in there without removing the DP, but can you get it far enough out of the way to get a wrench on the bolts that hold the separator in place? Maybe it will drop down far enough.

Gotpsi?

iTrader: (5)

Block of steal drill 2 holes grind to shape. Done

NA6C-Guy

iTrader: (1)

I wouldn't recommend stealing a drill for this project. Or two holes grinding for that matter, at least *** to ***.