nvmx-5

I'm just wondering if a Corbeau A4 will fit in a 90 miata these seem to look like the most comfortable for my fat *** (6ft, 225lb). I've seen a couple online but no info how they were mounted. Will i need to do custom work?

cjernigan

iTrader: (13)

Depending on how you want to bolt it up you usually always have to do custom work. Bolting it to the floor can be done with homemade brackets most the time if it is a bottom mount seat versus a sidemount. Sometimes you can buy rails that it will bolt to, or even modify the stock rails to work. All depends on how low you want to go.

Newbsauce

iTrader: (2)

Pretty much every damn seat in my experience so far requires custom work. I've fitted both generic seats and now momo starts. I use stock rails and basically force them to work.

Braineack

iTrader: (62)

http://www.flyinmiata.com/tech/seats.asp

nvmx-5

i went by this because i baught a pair of sparco roadster but they won't fit without a custom work

nvmx-5

yeah i think i'm going to have to make barckets but i was wondering if it'll fit without cutting parts off from the seat.

that7guy

iTrader: (1)

I have a corbeau seat with the Miata bracket from Corbeau. Fits perfect with no modding necessary!

firedog25

My Corbeau rails had to be slightly modified to fit the passenger side... a little grinder drum on the Dremel for a couple of seconds made it work perfect.

JasonC SBB

If you have like a 36" waist the regular A4 will be tight. They have a "wide" version.

Kelly

iTrader: (6)

The A4 is gonna sit up pretty high.

JasonC SBB

Will your head end up higher than stock?

Kelly

iTrader: (6)

Most likely..unless you forgo the slider.

Redbaron

Will fit in a miata w/slider side of seat rests against side of car though