RotorNutFD3S

iTrader: (33)

I'm getting wonderful squeaky noises from under the car now, and after some checking and prodding, and considering the age of the car, I've decided it's probably a good time to do the bushings since they are still the OEM ones ('95, 75k miles).
However, who sells them? I've seen the ones FM and Rosenthal has to offer, but I know that there has to be other vendors out there. Energy Suspension only seems to do sways, so what has anyone else used?

spike

Goodwin racing sells polyurethane bushings and the MS bushings.

Vashthestampede

iTrader: (17)

Don’t the polyurethane performance bushings make even more sqeeek? I could be wrong though...just thought I remembered reading that at some point.

http://www.miatamania.com/Shop/ViewP...eIndexID=36335

Vash-

Rage_Kage

if you buy from fm make sure they have them in stock. when i ordered mine they were in australia, two months later my bank account was overdrafted after a $400 charge because they shipped without telling me.

Arkmage

iTrader: (3)

The FM ones are what I'm running... no squeeks for the first 9 months and 15K miles... now one corner is starting to squeek. You get used to it. If the top is down you can't hear it over the wind noise @ speed above 15 mph. If the top is up you can't hear it over the stereo at low volume.

There is also an australian company I ran across yesterday looking for volvo suspension. I can't remember their name but they has stuff for miata's and it was about the same price as FM.

SOL General

iTrader: (-1)

Are the bushings easy to replace?

mazda/nissan

iTrader: (2)

how much noise can they produce? i have a problem with my front left.... it wasn't bad until i wrecked and then i had to replace the struts since one was always bottoming out, but it is still rattlin' and clanking, could this be a bushing or a loose spring/strut?

Vashthestampede

iTrader: (17)

I think sometimes its a PITA getting the old ones out...

Vash-

spike

The Powerflex poly bushings are designed not to squeek,unlike the other brands.

Arkmage

iTrader: (3)

It's not too bad... figure on 2 hours/corner if you have done miata suspension before. 4-5 hours a corner if not. I think it took me and a buddy each working on one side of the car about 7 hours to do all 22 bushings.

Juffa

I think you are referring to the Aussie made super pro bushes, I believe that these are what FM sell. I and a number of other Aussies have these in our MX-5s and love them.

www.superpro.com.au

J

Rage_Kage

its not hard just very time consuming,

Arkmage

iTrader: (3)

nope... superpro is what FM sells... I'm talking about another vendor that I haven't seen until just recently.

gwilo

There is this set of bushings

Maruha/Mazdaspeed bushing set

http://eunos.ca/catalog/product_info...roducts_id=323

Also there is a set that has some bushings Poly and some rubber. Apparently it is not expensive, gives a good ride without being to firm.